An RGB LED can mix almost any color, which makes it useful for creative portraits: a colored rim light, a colored background, or a split-color look. Keep the main light on the face close to neutral, because strong color on skin is unflattering. Set a fixed white balance too, so auto white balance does not cancel the color you chose.
RGB, RGBW, RGBWW and multi-emitter
- RGB: red, green and blue emitters only. White output is often poor, so skin tones can look off.
- RGBW and RGBWW: add white emitters. RGBWW adds both warm and cool white, which gives better skin tones.
- Multi-emitter: more color emitters for a wider range of colors. RGBACL, from Aputure, is one example. Naming varies by brand.
Color modes and what they mean
- CCT: white light at a set color temperature, often 2700–6500 K, with a green or magenta tint control. Some lights go from 2000 K to 10,000 K.
- HSI: hue, saturation and intensity. Hue angles run red 0°, yellow 60°, green 120°, cyan 180°, blue 240° and magenta 300°.
- RGBW sliders: direct control of each channel.
- Gel presets: emulations of common theatrical and photographic gels.
- x/y coordinates: exact color placement on a color chart.
- Effects: fire, police, lightning and TV modes. They are fun, but they rarely suit a flattering portrait.
Saturation and intensity
In HSI mode, saturation sets how far a color is from white. Zero percent is white, and 100 percent is pure color. Intensity sets brightness separately.
Why saturated color looks dimmer
Output drops a lot as colors become more saturated. Deep blue and red are much dimmer than white at the same intensity. The same intensity setting does not give the same brightness in every color, so check the light’s output as you change colors.
Portrait setups
- Neutral key with a colored rim or background. A neutral white key lights the face, and a colored rim or background adds the mood.
- Split color. Two complementary colors from opposite sides, a colored take on split lighting, for example a warm and a cool color, create contrast across the face.
Keeping skin near neutral
Keep the light on the face near neutral or slightly warm. Strong color on the face exaggerates blemishes and makes skin look unnatural. Put the colored light on the background or along the edges of the subject instead.
Exposure and camera settings
- Set a fixed white balance, such as 5600 K. Auto white balance cancels the creative color.
- Saturated colors clip a single RGB channel early. Underexpose by about 0.3–1 stop, and watch the RGB histogram.
- Continuous LEDs have much less output than flash. A starting point is f/1.8–f/2.8, ISO 400–1600 and 1/125 s. Adjust from there.
Flicker and banding
Some LEDs use PWM dimming, which can cause banding at fast shutter speeds or at low intensities. Test the light at your planned settings before the shoot. The effect varies by light.
App control and formats
Many RGB lights connect to an app, such as Sidus Link (used by Aputure and amaran), Godox Light or NanLink. Common formats include pocket panels, tube lights such as PavoTube and Infinibar (or a DIY tube light), and larger COB lights with RGB. Check the specifications of any model before you buy.
Common mistakes
- Assuming every RGB light makes good white. RGB-only white often renders skin poorly.
- Expecting the same intensity to give the same brightness in every color. Saturated colors are dimmer.
- Thinking a high CRI means accurate saturated color. CRI measures white light only.
- Leaving auto white balance on. It neutralizes the look.
- Assuming a fast shutter is always safe with LEDs. Flicker banding can appear.
Safety
Don’t stare into high-output LEDs. Give models breaks from bright, saturated light.