Portrait Lighting

What Lighting Do You Need for Portrait Photography?

One key light and a reflector covers most portraits. Learn key placement, hard versus soft light, the main lighting patterns and the gear that matters.

On this page
  1. Start with one key light and a reflector
  2. Hard light and soft light
  3. Where to put the key light
  4. Five patterns to know
  5. Modifiers and light sources
  6. Fill, reflectors and the three-light setup
  7. Lighting ratios
  8. Common mistakes
  9. Where to go next

Start with one key light and a reflector

For most portraits, one key light and a reflector is enough. The key is the main light on the face. A reflector on the opposite side bounces some of that light back into the shadows, so the shadow side doesn’t fall into darkness. You can add lights later, but one light is the best place to learn, because it shows how position and softness change a face.

If you are deciding what to buy first, a large, soft modifier for one light and a 5-in-1 reflector is a sensible start. A window also works, and costs nothing.

Hard light and soft light

Light quality depends on two things: how large the light source is compared with the subject, and how close it sits. A large source close to the face gives soft light, with smooth transitions and shadows that fade gently. A small source, or a large one placed far away, gives hard light, with crisper edges and deeper shadows.

A softbox isn’t soft by default. Placed a few metres from the subject, it behaves more like a smaller, harder source. Move it closer and the same box gives much softer light.

Distance also changes brightness quickly. Under the inverse square law, doubling the distance between light and subject cuts the light to about a quarter, roughly two stops less. Adjust distance before you add power.

Soft light is usually the flattering choice for skin, and it is the more forgiving option when you are learning. Hard light can work well for drama, but it shows more texture and needs more care with placement.

Where to put the key light

A common starting point is:

  • About 30 to 45 degrees off the camera axis, so the light comes from one side of the lens.
  • About 30 to 45 degrees above eye level, angled down toward the face.

From there, small changes in the key’s angle create the named lighting patterns below. Turning the subject’s head changes the pattern as well, so the pose and the light position work together.

Five patterns to know

Pattern Key position Effect
Butterfly (Paramount) High, directly in front of the face A small shadow under the nose; cheekbones lifted
Loop About 30 to 45 degrees to one side, slightly above eye level A small nose shadow that does not touch the cheek shadow
Rembrandt About 45 degrees to one side, well above eye level A small triangle of light on the shadow-side cheek
Split About 90 degrees to one side Half the face lit, half in shadow
Short and broad Short lighting lights the side of the face turned away from the camera; broad lighting lights the side facing the camera Short lighting tends to slim the face; broad lighting makes it look wider

Rembrandt lighting is covered in how to do Rembrandt lighting, split lighting in split lighting portraits, and dark, moody looks in low-key portrait lighting.

Modifiers and light sources

A modifier shapes the light before it reaches the subject. Common sizes for portraits are:

  • Softbox: about 24 to 36 in (60 to 90 cm). See the softbox size guide. A good size for head and shoulders.
  • Octabox: about 36 to 60 in (90 to 150 cm). Softer edges and larger catchlights.
  • Umbrella: about 33 to 60 in. Cheap and quick to set up, and it spreads light more widely than bare flash.
  • Beauty dish: about 16 to 22 in. A crisper, punchier look than a softbox.
  • Window: a large window with indirect light is a free, soft source.

The light itself can be:

  • Speedlight (flash): small and relatively inexpensive, with a lot of light for the money. You can’t see the light before the shot.
  • Battery strobe: more power, and still portable.
  • Continuous LED: you see the light as you shoot. Look for a colour rendering index (CRI) or TLCI of about 95 or higher for accurate skin tones.

Fill, reflectors and the three-light setup

Fill lifts the shadows. A white or silver reflector, or a white foam board, placed on the shadow side does this without extra power. A black board does the opposite: it is negative fill, which deepens the shadow side for shape and contrast.

The classic three-light setup adds two lights to the key:

  1. Key: the main light, placed as described above.
  2. Fill: on the opposite side of the camera, at lower power, to lift the shadows.
  3. Hair or rim light: behind the subject, to separate hair and shoulders from the background.

Add these one at a time. Each light changes the shadows the others create.

Lighting ratios

A lighting ratio compares the brightest and darkest parts of the face. Stops are often easier to think in:

Difference between key and fill Ratio
1 stop 2:1
1.5 stops 3:1
2 stops 4:1
3 stops 8:1

Much portrait advice mentions an “80/20” split. That is a key-to-fill ratio of about 4:1, or two stops, so treat it as a rule of thumb rather than a standard.

Common mistakes

  • Chasing watts. Modifier size and control matter more than raw power.
  • Believing you need three lights. One light and a reflector is a complete starting point.
  • Making a ring light the default. It gives flat, even light with ring-shaped catchlights. That is a style, not a universal choice.
  • Blaming flash for harshness. Harshness comes from the size of the source and its distance, not from flash itself.

Where to go next

Once one light is working, the spoke guides show how the same principles apply in particular situations. For a home studio, see how to light a headshot at home and model photography at home. For darker skin tones, see lighting darker skin tones in photos. For the budget question, see the best photography light for home use.

Sandbag light stands, especially those carrying large modifiers or boom arms, and keep hot lights away from fabric and paper backdrops.

Keep exploring

Guides from other topics

All topics →