Short answer
Newborn studio lighting aims to look like soft window light. The usual setup is one large, soft source, placed at about 45 degrees to the side and slightly above the baby, with a white reflector on the shadow side. The light is usually gentle, around 2:1, and the baby’s safety comes before any shot.
Why low power suits newborns
A large, low-power light lets you open the aperture for a soft background and place the light close enough to wrap the baby without deep shadows. A high-powered light often has to be stopped down or moved further away, which makes shadows harder and reduces background blur. For these reasons, many newborn photographers choose lower-powered lights.
A standard newborn setup
- Light: a 48 to 60 in octabox, or a large window, at about 45 degrees and slightly above the baby.
- Direction: light should flow from the baby’s head toward the feet. Avoid lighting from below.
- Fill: a white reflector or V-flat on the shadow side.
- Diffusion: bounced or diffused flash, rather than bare flash aimed at the baby’s face.
For the background and the distance it needs from the subject, the same principles apply as in model photography at home.
Strobe or continuous light
Both work.
- Continuous LED lets parents and the photographer see the light as the shot is set up.
- Strobe freezes movement, which helps when the baby is wriggling.
Choose based on what you shoot most and what your space allows.
Camera settings
Typical starting points are 1/125 to 1/200 s, f/2.8 to f/5.6, and ISO 100 to 800, depending on the light. Keep the exposure consistent across a session, and keep the ISO as low as the light allows.
Protect highlights
Newborn skin blows out easily, so brighter is not better. Check the histogram and reduce the power, or move the light back, if the skin looks overexposed. A polariser or a change of light angle reduces glare on glossy surfaces, such as the surface of a milk bath.
Milk bath shoots
A milk bath shot places the baby in a shallow bath of warm water and milk, usually photographed from directly overhead. The milk turns the water opaque, which makes the bath look like a clean surface.
- Mix: warm water with whole or powdered milk, stirred until the water is opaque. The ratio varies, and a small amount of milk is usually enough.
- Temperature: close to body temperature, about 37 °C (98 to 100 °F). Check by hand or with a thermometer.
- Angle and light: shoot from directly overhead, with soft window light or a large softbox from one side.
- Who it suits: a baby who can sit with support, typically around six months or older, and maternity shoots. A very young newborn needs constant support, so many photographers wait until the baby can sit supported.
Safety first
Newborn work needs strict safety rules.
- Never leave a baby unattended in a milk bath, not even for a second.
- Keep a spotter’s hand within inches of the baby during all posing.
- Sandbag every stand near the posing area, and keep nothing overhead without a safety cable.
- Keep hot lights out of reach of the baby and the set.
- Keep the room warm. A room around 24 to 27 °C (75 to 80 °F) is typical for unclothed newborns.
On flash, there is no good evidence that diffused studio flash harms a baby’s eyes. Still, avoiding bare flash aimed at the face is a sensible habit.
Posing note
Many familiar poses, such as “froggy” and head-in-hands, are often composites built from several frames, with a spotter’s hands edited out. Plan for a spotter to be present at every pose, and don’t treat a single frame as proof that the baby held the pose unaided.
For low-key looks with a dark background, see low-key portrait lighting. For the general principles of light and pattern, see what lighting you need for portrait photography.