Portrait Lighting

Hollywood-Style Portrait Lighting: How to Recreate the Classic Glamour Look

Recreate classic Hollywood glamour lighting with a high, hard key, feathered light and deep shadows, using modern gear in place of vintage spotlights.

On this page
  1. The look in short
  2. Where the look came from
  3. The high, hard key
  4. Feathering the key
  5. Hair light, kicker and background spot
  6. Contrast and deep shadows
  7. Recreating the look with modern gear
  8. Posing that suits the light
  9. Common misconceptions
  10. Safety

The look in short

Hollywood glamour portraits, from roughly the 1920s to the 1950s, relied on hard, focused light, a high key placed in front of the face, and shadows left deep. The look depends more on where the light falls and how little fill there is than on any single piece of equipment.

Where the look came from

Photographers associated with the style include George Hurrell, Clarence Sinclair Bull, Laszlo Willinger and Ruth Harriet Louise. They worked with hard, focused tungsten Fresnel spotlights, not the large softboxes common today. Many portraits were shot on large-format film, usually in black and white, and retouched heavily on the negative.

The high, hard key

The signature pattern is butterfly lighting, also called Paramount lighting. The key sits high and directly in front of the face, casting a small shadow under the nose. Many of these portraits used a key on a boom above the camera, and the overhead boom key is often associated with Hurrell’s work.

To get the look, start with the key above and in front of the subject. Lower it or move it until the nose shadow is short and sits just above the upper lip.

Feathering the key

A hard light gets a softer, more flattering edge by feathering. Aim the light so its hot centre falls on the eyes and its edge falls off down the body. The falloff creates a gradient across the face, rather than a flat, bright patch.

Grids and snoots keep the beam controlled, so the light doesn’t spill onto the background.

Hair light, kicker and background spot

Several extra lights were common in these portraits:

  • Hair light from behind or above, separating the hair from the background.
  • Kicker (rim light) on the cheek or shoulder, adding a bright edge.
  • Background spot: a gridded light aimed at the backdrop, creating a pool or gradient of light behind the subject. Aim it low or high on the backdrop to shape the gradient.

Contrast and deep shadows

Contrast in these portraits was high, often around 4:1 to 8:1 (2 to 3 stops), with little or no fill. The deep, unfilled shadows were part of the look, not a mistake. To get there, skip the reflector, or use a black board for negative fill, and let the shadow side fall off.

Recreating the look with modern gear

Several tools stand in for the vintage Fresnel:

  • Optical snoots or projection attachments for a tight, controllable beam.
  • Bare reflectors with 10 to 20 degree grids, which give a crisp edge with little spill.
  • LED Fresnel attachments, which give a focused beam from a modern LED light.
  • Grids and snoots on every light to keep spill off the background.

Modern LEDs run cooler than tungsten, but the principle is the same. The portrait lighting pillar explains the butterfly pattern and the other patterns in more detail.

Posing that suits the light

  • Chin raised slightly, with the eyes turned toward the light.
  • A strong jawline shadow, which gives definition.
  • Hands near the face, which add shape to the frame.

Change one thing at a time. The pose changes how the light falls as much as the light does.

Common misconceptions

  • “Hollywood glamour used big softboxes.” It relied on small, hard spotlights.
  • “Butterfly lighting is the only Hollywood pattern.” Loop and Rembrandt variants were common too.
  • “Converting to black and white gives the look.” The look depends on where the hard light falls. Black and white is part of the finish, not the cause.
  • “Shadows were filled in.” Deep, unfilled shadows were central to the style.

If you want a darker version of the same contrast, see low-key portrait lighting.

Safety

Tungsten Fresnels get very hot. Use gloves when you adjust them, keep them clear of anything flammable, and never leave them unattended while they are on.

The complete guide to portrait lighting

What Lighting Do You Need for Portrait Photography?
Read the guide

Keep exploring

Guides from other topics

All topics →