Short answer
For a small group, use one large light high and in front of the camera. For a wider group, use two lights in a crossover pattern. Indoors, a speedlight bounced off a white ceiling can cover a small group. Outdoors, larger groups need strobes to compete with daylight.
Small groups: one large light above the camera
A single large light, such as an umbrella or octabox, placed high above the camera covers small groups of up to about six to eight people. It gives everyone soft, even light without one person casting much shadow onto another.
For more even light across the rows, move the light further back and raise the power to match. The further the light sits, the less the brightness changes from the front row to the back.
Two-light crossover for wider groups
Place one light on each side of the group, a simple form of multiple off-camera flash, each at about 30 to 45 degrees from the camera axis. Aim each light at the far side of the group and feather the beam, so the edges fall off. The two lights overlap in the middle and light the whole group evenly.
For the portrait lighting pattern behind this, the key angle principles are the same as in a single portrait.
Depth of field across rows
Faces in a group sit at different distances from the camera, so depth of field matters:
- One row: f/5.6 is often enough.
- Several rows: f/8 to f/11 keeps every face sharp.
A wide aperture, such as f/2.8, leaves the back rows soft.
Speedlights: bounce, power and recycle
Speedlights are compact and affordable, but they have limits.
- Bounce off a white ceiling for small indoor groups, in a room where the ceiling is about 3 m (10 ft) high or lower. The ceiling becomes a large, soft source, as long as it is white; a colored ceiling tints the bounce.
- Use bare flash or an umbrella for larger groups, since they throw more light.
- Expect slow recycling at high power. At half to full power, a speedlight can take roughly 3 to 7 seconds to recycle. At a lower power, such as 1/4, with a higher ISO of 400 to 800, you can shoot faster.
If you are weighing speedlights against larger flash for home use, see the best photography light for home use.
Large outdoor groups
Big outdoor groups usually need strobes in the 400 to 600 Ws range to compete with daylight. A single speedlight is usually not enough power for a team of 30 outdoors. Place the group in open shade where you can, or use flash as fill so faces aren’t underlit against a bright sky. For more on outdoor light, see outdoor fashion photography lighting.
Raise the camera slightly, on a stepladder if needed, so the back rows aren’t hidden and the light reaches every face.
Glasses glare
Glare on glasses happens when the angle of the light matches the angle of the lens. Raise the lights and set them wider, so the reflections bounce away from the camera.
Photo booths
Photo booths need flat, even light that flatters everyone in the frame.
- Light the subject from a large softbox or umbrella next to the lens, or use a ring light or beauty dish at the lens for an even look.
- Use starting settings of manual exposure, 1/125 to 1/200 s, f/5.6 to f/8, and ISO 200 to 400.
- Keep the backdrop about 1 to 1.5 m (3 to 5 ft) behind the guests to limit shadows on it. Light the backdrop separately if you want it pure white.
- Use flash on manual power rather than TTL, so exposure stays the same from shot to shot. TTL can vary with clothing and group size.
Common mistakes
- On-camera direct flash. It gives flat light, red-eye and dark back rows.
- Wide apertures for groups. At f/2.8, the back rows will be soft.
- One speedlight for a large outdoor team. It is usually not enough power.
- TTL for booths. Exposure can change from shot to shot.
Sandbag stands in event spaces, and tape down cables so guests don’t trip on them.