One soft light, one reflector and a plain backdrop
Home model photography works well with a small kit: one large, soft light, a reflector for the shadow side, and a plain backdrop a short distance behind the model. You don’t need a studio. You do need a plan for where the light, the camera and the model will sit, because the room sets the limits.
Plan the room
A room about 3 m by 4 m is enough for head-and-shoulders and three-quarter shots. Full-length vertical frames need more distance from the camera, so measure the room before you buy modifiers. For the wider room plan, see how to create a home photography studio.
Many home ceilings are around 2.4 m (8 ft). That limits how high a light can sit. Use a boom arm or a low-profile modifier, and keep the light within the height the ceiling allows.
Camera distance and lens
Distance depends on focal length and the framing you want. As rough starting points on a full-frame camera:
- Full-length, vertical: about 2.6 m (8.5 ft) at 50 mm, or about 4.5 m (15 ft) at 85 mm.
- Head and shoulders: about 1.2 m (4 ft) at 85 mm.
A longer lens lets you stand further back, which keeps faces natural. Shooting wide and close enlarges features and distorts faces and limbs, so a wide lens doesn’t solve a small room. Check the framing on your own camera, since these numbers are only a starting point.
Backdrop distance and width
Place the model about 1 to 2 m (3 to 6 ft) in front of the background. That gap reduces the shadow the model casts on the backdrop and limits light spill onto it.
Seamless paper usually comes in widths of about 53 in (1.35 m), 107 in (2.72 m) and 140 in (3.55 m). The narrowest width suits head-and-shoulders only, because it is too narrow for a full-length pose.
A starter one-light setup
- Place a 36 to 48 in octabox or umbrella at about 45 degrees to one side of the model.
- Set it slightly above the model’s eyes.
- Put a white reflector on the shadow side, close enough to lift the shadows.
- Start at about f/4 to f/8 and ISO 100 to 400, then adjust the light’s power to get the exposure.
Move the light closer to make it softer before you add power. A light placed closer and a little less powerful often looks better than a strong light far away. At home, about 100 to 200 Ws of strobe or 60 to 150 W of LED is often enough at these settings.
Fill and the 80/20 idea
Fill lifts the shadows, and a reflector does this without extra power. Many photographers aim for a key-to-fill ratio of about 4:1, or two stops, sometimes called an “80/20” split. Judge it on the back of the camera or the histogram rather than by the rule alone.
Negative fill, a black foam board on the shadow side, deepens shadows for shape.
Mixed light and white walls
Room lights change the colour of the image. Tungsten room bulbs are roughly 2700 to 3000 K, while daylight and flash sit near 5500 K. Turn the room lights off, or gel them to match, so the light stays consistent.
White walls and ceilings bounce light back into the scene. That softens shadows but also reduces contrast, and an unlit white wall often looks grey in the photo. Use black foam board or a sheet to take light away where you want deeper tones. Use a grid or a flag to stop light spilling onto nearby walls and curtains.
Practise on a mannequin head first
A mannequin head lets you try placements before the model arrives. Set it at the model’s eye height, then test loop, Rembrandt and butterfly positions. Move the light, look at where the shadows fall, and note the settings that work.
A mannequin doesn’t reproduce skin. Its surface is often glossier and paler than a real face, so highlights behave differently. Use it to learn shape and placement, not to predict exactly how a person will look. The portrait lighting pillar explains the patterns you will be testing.
Shoot the model
- Set the camera at the model’s eye level, or slightly above, unless you want a low, dramatic angle.
- Ask the model to change expression and shift their weight between frames, and take several frames for each pose.
- Check the histogram as well as the screen, because the screen can be misleading in a bright room.
If you are using a low-power light, a headshot setup with one softbox uses the same principles at closer range. For dark backgrounds, see low-key portrait lighting.
Safety at home
Sandbag light stands, especially those with large modifiers, and tape cables down so no one trips over them. Keep hot continuous lights away from curtains and paper backdrops, and follow the spacing the manufacturer specifies.