To light a seamless paper backdrop at home, light the paper separately from your subject, so you can set its brightness on its own. For a white background, use one light on each side of the paper, or a single light behind the subject. Then set the paper’s exposure for the look you want: white, grey or black.
What you need
- Seamless paper in 53 in (1.35 m), 107 in (2.72 m) or 140 in (3.55 m) widths. A 107 in roll is often 36 ft (11 m) long.
- A background stand or roller system that spans the paper. A 107 in roll needs roughly 9 to 10 ft (2.7 to 3 m) of support width.
- Sandbags, gaffer tape and A-clamps to hold the paper and stands in place.
- At least two background lights for the two-light method, or one for the single-light look. You will also need your subject lights.
Hang and curve the paper
Form a gentle sweep, or cove, where the paper meets the floor. Do not crease it, because creases show in the frame. Tape the end down with gaffer tape, and sandbag the stand.
Method 1: Two lights for white
- Place one light on each side of the backdrop, angled about 45° toward the paper. Hide the lights behind or beside the subject so they stay out of the frame.
- Aim for even coverage across the paper, to within about one-third of a stop. Meter several points, or check the highlight warning on your camera.
- Flag the lights so they do not flare into the lens.
Method 2: One light behind the subject
A single light behind the subject, aimed at the paper, gives a gradient or halo effect. It is quicker to set up than the two-light method, but the paper will be less even.
Set the background exposure
- White: as a starting point, set the background about 1 to 1.5 stops brighter than the key light on the subject. The same starting point works for white background product shots. Check that the paper reads as white, with a highlight warning or RGB values near 250–255.
- Overexposure limit: overexposing the background by more than about 2 stops causes flare, lower contrast and light wrapping onto the subject’s edges.
- Grey: use grey paper exposed at about the same level as the subject, and it renders as mid-grey.
- Black: keep key light spill off the paper with grids, flags and distance. Paper that is 2 to 3 or more stops under the key reads close to black. Black paper alone does not give a black background. Spill control does.
Subject distance from the paper
- Keep the subject at least 4 to 6 ft (1.2 to 1.8 m) from the paper.
- For a white background, many photographers place the subject 6 to 10 ft (1.8 to 3 m) out, which reduces light wrapping onto the subject’s edges.
- For a black background, put the subject as far from the paper as your room allows.
Full-length shots and the floor
The floor section of the paper gets less light than the upper part. For full-length work, you may need an overhead light or an extra light for the lower sweep.
Colour on paper
Saturated colour needs grey or white paper exposed at or below the key light. Overexposed paper washes gels out.
Common misconceptions
- White paper is not white in the camera without its own light.
- Black paper alone does not give a black background. Spill control does.
- More background power is not always better. It causes flare and halos.
- Wrinkles and footprints do not disappear when you overexpose them. Cut and pull fresh paper instead.
Safety
- Sandbag backdrop stands. A falling roll and crossbar can injure people.
- Tape the paper edge and cables down so people do not trip.
For distance and falloff, see how far studio lights should be from your subject.