A garage can make a workable studio, especially for headshots and product shots. Measure the space, cover the door and windows, plan for temperature and humidity, and check your power before you buy lights. Full-length work needs more depth than many single-car garages provide. If you are starting from a spare room instead, see how to create a home photography studio.
Measure the space first
- A typical single-car garage is about 12 × 20 ft. Two-car garages are often about 20 × 20 ft to 24 × 24 ft. Sizes vary, so measure your own.
- Many garages have ceilings around 8 ft. That limits overhead lights, boom arms and full-length framing.
- Shoot along the longest dimension, or along the diagonal, to get the most distance.
- Keep the subject about 4–6 ft (1.2–1.8 m) from the backdrop to avoid cast shadows and control spill.
For full-length shots, distance depends on the lens. On a full-frame camera held in portrait orientation, a standing adult with a little room above the head needs roughly 10 ft (3 m) of distance with a 50 mm lens, and roughly 16 ft (5 m) with an 85 mm lens. These are starting figures, so check with your own camera.
Control the light
- Seal door gaps and windows with blackout fabric. Daylight that changes through the day will fight your lights.
- Switch off the garage door opener’s light if it sits near the set.
- Treat an open door as uncontrolled light, not a softbox. It shifts with the weather and the time of day.
Walls, ceiling and floor
- Walls and ceiling: paint them white to bounce fill light, or dark grey or black for more control. Pick one look rather than trying to mix them.
- White walls reflect a lot of light, which lowers contrast and makes low-key looks harder to get.
- Floor: bare concrete sheds dust, and dust shows on seamless paper. Seal the floor, or cover it with rubber mats or vinyl. A hard floor also gives stands a steady base.
Backdrops and storage
Wall- or ceiling-mounted roller systems, including three-roll systems and ceiling rails, save floor space. Store paper rolls dry and off the floor. Hang stands, modifiers and rolls on hooks or shelves so they are off the floor when you are not shooting. If you park a car in the garage, move it outside for shoots.
For lighting the paper itself, see how to light a seamless paper backdrop at home.
Power
A garage often runs on a single 15–20 A circuit, and that circuit may also feed a freezer, a compressor or a heater. Check what else shares it before you plug in several strobes.
Under US electrical code, garage outlets are generally required to be GFCI-protected. Check your local rules. Use heavy-gauge extension cords, and do not overload them.
Temperature and humidity
- Cold reduces battery life and slows recycle times.
- Condensation can form when cold gear moves into warm air. Let gear warm up gradually, in a sealed bag if you can.
- Humidity makes paper backdrops wrinkle and curl. Trouble starts at roughly 60% relative humidity, and a dehumidifier helps.
- Insulation and a heater or fan make longer sessions workable and keep subjects comfortable. Choose electric heaters, and keep them away from paper and stands.
Common misconceptions
- A single-car garage can work for headshots and products. Full-length work needs more depth.
- An open garage door is not a softbox. It is uncontrolled and changes as the light changes.
- White walls are not always the best choice. They cut contrast, which makes low-key looks hard.
- Bare concrete is not a neutral floor. It shows in shots and kicks up dust.
Safety
- Never run a car or a fuel-burning heater in a closed garage. Carbon monoxide can build up quickly.
- Keep hot lights away from stored fuel, solvents and paint.
- Sandbag stands on hard concrete floors.
- Use heavy-gauge extension cords, and do not overload them.
For gear costs and what to buy, see the photo studio equipment list.