Portrait Lighting

Low-Key Portrait Lighting: Dark Backgrounds and Moody Results

Low-key portraits pair a dark frame with a well-exposed face. Learn the flash-off test, how to keep light off the background, and rim light choices.

On this page
  1. The short answer
  2. What low key means
  3. The flash-off test
  4. Light close, subject far
  5. Control spill
  6. Background choices
  7. Ratio and patterns
  8. Separation with a rim or kicker
  9. Low key from a window
  10. Common mistakes

The short answer

A low-key portrait has a mostly dark frame, with the face correctly exposed and lit. Put the light close to the subject, put the subject well away from the background, and control spill with grids, snoots or flags so the background stays dark.

What low key means

Low-key images are mostly dark tones with selective highlights. The histogram is weighted to the left, meaning most of the tones are dark. Only the surroundings should go dark. The subject should stay correctly exposed, because low key is not the same as underexposure.

The flash-off test

Before you set up, take a test shot with the lights off at your planned settings, such as 1/200 s, f/8 and ISO 100. The frame should look close to black. If it doesn’t, ambient light is reaching the background, and you’ll need to reduce it.

Light close, subject far

The inverse square law works in your favour here. Place the light close to the subject, and place the subject 2 to 3 m or more in front of the background. The light falls off quickly, so the background stays dark while the subject stays lit.

Control spill

Spill is light that lands where you don’t want it. Use these tools to keep it off the background:

  • Grids of 10 to 30 degrees, for a narrow, controlled beam.
  • Snoots for a small, focused spot.
  • Strip boxes or feathered softboxes for soft light that falls off quickly.
  • Flags and black cards to block light from reaching the background or the lens.

Soft light works too, as long as you control where it goes.

Background choices

  • Black velvet absorbs the most light, as in black background photography, then black muslin, then black paper.
  • A grey or white wall can go black if it is far from the subject and unlit.

Ratio and patterns

Typical low-key ratios run from 4:1 to 8:1 or more, which is 2 to 3 stops or more, with little or no fill. Rembrandt, split and short lighting are common patterns for this look. For the pattern details, see how to do Rembrandt lighting and split lighting portraits.

Separation with a rim or kicker

Dark hair or dark clothing can blend into a dark background. A rim, kicker or hair light separates them. Dark clothing helps the subject sink into the frame, while bright clothing pulls attention away from the face.

Low key from a window

A window can produce low-key light. Use a small window opening in an otherwise dark room, and seat the subject close to it, so the light reaches the face while the room behind stays dark.

Common mistakes

  • Underexposing the face. Low key means the background is dark, not the subject.
  • Believing you need a black backdrop. Distance and spill control do most of the work.
  • Darkening the image in post. Crushing shadows later loses shadow detail and control.
  • Assuming only hard light works. Gridded soft light works too.

In a dark studio, tape down cables and mark stand legs so no one trips over them. For a lighter, broader approach to the same portrait, see what lighting you need for portrait photography.

The complete guide to portrait lighting

What Lighting Do You Need for Portrait Photography?
Read the guide

Keep exploring

Guides from other topics

All topics →