Put the light behind the fog, pointing toward the camera, and keep the background dark. Avoid front light, which makes fog look flat and gray. After each burst, give the fog 30–60 seconds to spread, so it does not clump. For the machine itself, see how to use a fog smoke machine.
Backlight or side light the fog
Place the light about 90–180° from the lens axis, behind the fog and aimed toward the camera. Side light at about 90° shows texture and depth. Front light, from beside the camera, makes fog nearly invisible.
Keep the background dark
Fog shows as light scattered against shadow. If the background is bright, the fog gets lost in it. Lower the ambient light so the lit fog dominates the frame.
Hard or soft light
- A hard, narrow source, such as a bare flash, a fresnel, a spot or an optical snoot, makes visible beams.
- Soft light gives an even glow. A softbox will not produce defined shafts.
Choose the light for the look you want: beams or glow.
Hide the light and control flare
Put the light behind the subject or just outside the frame. Flag it to control lens flare. A lens hood and a clean front element also reduce veiling flare when you shoot toward a light.
Let the fog settle
After a burst, wait 30–60 seconds so the fog spreads evenly instead of in clumps. Haze gives an even, lingering atmosphere, and fog bursts give dense clouds. Indoors, turn off fans and the HVAC. Outdoors, shoot quickly, because wind moves fog fast.
Exposure for fog
- Shoot in manual mode.
- Expose for the lit highlights of the fog, then underexpose slightly to keep the contrast.
- Auto exposure misleads here, because the camera’s meter assumes middle gray. It underexposes bright fog and overexposes dark, backlit scenes.
Natural fog
For natural fog, shoot toward the sun at a low angle, early in the morning. A telephoto lens can stack fog layers. Bright fog can meter gray, so you may need to add about +0.7 to +1 EV of exposure compensation. This is different from the underexposure advice above, which applies to artificial fog against a dark background.
Colored fog
Put colored gels on the backlights to tint the fog. Two complementary colors add depth. See colored gels for photography lights.
Common mistakes
- Thinking more fog makes it more visible. Too much flattens the whole frame.
- Lighting from the camera’s position. Front light washes the fog out.
- Using a softbox for beams. Soft light cannot make defined shafts.
- Trusting auto exposure. It misreads bright fog and dark, backlit scenes.
Safety
- Fog can set off smoke detectors. Get the venue’s permission and check with staff before you start.
- Fog residue makes floors slippery. Clean up after the shoot.