What a silver reflector does
A reflector doesn’t add light. It redirects light that is already there, such as sunlight, window light or flash, and sends some of it back into the shadows. Silver is the most reflective common option, so it gives the brightest, most contrasty fill.
Silver vs white vs gold
- Silver. Reflects more light than white and is roughly color-neutral. It gives a brighter, more specular, more contrasty fill. Silver is punchier and more efficient, but it’s not an upgrade over white in every case.
- White. Softer and lower in contrast than silver. A good choice when you want gentle fill.
- Gold. Warms the light. It can flatter some skin tones and look orange on others, so test it before you rely on it.
“Sunsilver” and zebra reflectors mix silver and gold. The exact gain of silver over white depends on the fabric, and matte “soft silver” fabrics are less harsh than bright silver.
Sizes and the 5-in-1 option
Common round sizes are 22 inches (56 cm), 32 inches (80 cm) and 43 inches (110 cm). Oval or rectangular reflectors are often around 42 by 72 inches (107 by 183 cm).
Many reflectors come as 5-in-1 units with silver, gold, white, black and translucent panels. The black panel subtracts light, and the translucent panel diffuses it. These give more options from one kit, but each panel is usually less flat and less bright than a single-purpose reflector.
How to aim a reflector
Angle and distance
The angle of incidence equals the angle of reflection. Tilt the reflector until the bounced patch lands on the subject’s face. Closer means stronger fill; farther means weaker fill.
Keep the reflector near face height and tilt it toward the face, so the fill comes in from the front or side. A reflector set too low and angled up gives unflattering “monster” up-lighting.
Clamshell fill
In a clamshell setup, a reflector sits below the face, angled up at about 45 degrees, with the key light above. The reflector fills the lower face and softens the shadow under the chin. Keep the angle gentle so the fill stays soft rather than creating harsh up-lighting. It’s a common and simple portrait setup.
What is the best reflector for sunlight?
There isn’t one best reflector for sunlight. A bright silver panel gives the strongest bounce, but in direct sun it can be too harsh and make the subject squint. A white or softer silver panel gives a more manageable fill. Moving the reflector farther back weakens the fill, which can be enough to calm it down. For more on working in harsh sun, see how to take good pictures in bright sunlight. Never bounce direct sun into anyone’s eyes.
How to make your own reflector
A simple reflector can be made from a rigid board covered with fabric or foil. How to make a DIY reflector from foam board walks through a build. Choose a surface with a clear, even finish, and keep the edges neat so the light doesn’t look patchy. A homemade reflector is worth trying, but a commercial pop-up often gives a more even and portable result.
What reflectors are made of
Most commercial reflectors use coated or woven fabric on a flexible frame. Silver and white are usually coated fabrics, while some budget or DIY versions use foil or board. Materials differ mainly in how even the surface is and how much light they return. Check the surface before buying if you need a smooth, bright highlight.
Holding and mounting
Reflectors are easiest with an assistant. Otherwise, use a reflector holder or arm on a stand, or a clamp on a C-stand. Bounce cards for products need a steady mount to hold their angle.
Common mistakes
- Assuming silver is always better. It’s a stronger, harder option, not an automatic upgrade.
- Expecting more light. A reflector only redirects light.
- Setting it too low. A low reflector aimed up gives unflattering up-lighting.
- Forgetting it can be too bright. Silver outdoors in sun can overpower the subject.
Safety
Large reflectors catch wind, so secure them outdoors. Pop-up frames spring open forcefully, so keep them away from faces when unfolding. Never bounce direct sun into anyone’s eyes.
Where to go next
For a shoot-through or reflective umbrella as a softer fill, see how to use a white umbrella in photography. To set up a reflector as fill in a one-light portrait, see how to set up photography lights for beginners. Reflective products need a different approach, covered in how to photograph something reflective.