Short answer
To make a lightbox for photography, cut windows in a cardboard cube and cover them with a white diffusion material, such as tissue paper, parchment or white muslin. Line the inside with white paper and add a seamless background. Light it with two LED lamps placed at about 45 degrees on each side. Shoot from a tripod, and set a custom white balance off a gray card.
Choose a size
A cardboard cube of roughly 16 to 24 inches suits most small products. Bigger boxes fit bigger items, but they need more light to fill evenly. Ready-made light tents come in similar sizes. Make sure you can reach inside to place and move the product.
If a full box is more than you need, a window and foam board setup can do the same job for small products.
Build a cardboard cube
- Cut the windows. Cut openings in both sides and the top, leaving a frame of about 1 to 2 inches (2.5 to 5 cm). Use a sharp craft knife with a straightedge, and cut away from your hand.
- Cover the windows. Tape white tissue paper, parchment, white muslin or rip-stop nylon over each opening. Pull the material taut and tape the edges.
- Line the inside. Line the walls with white paper or white poster board.
- Add a seamless sweep. Tape a sheet of white poster board from the back wall down onto the floor, curved so there is no crease. The curve becomes a background with no visible line, the basis of white background product photography.
- Add black card (optional). Strips of black card inside the box define the edges of glass or shiny items.
Collapsible and foam board versions
- PVC frame. Use half-inch PVC pipe with three-way elbow corners, and cover the frame with white fabric. Leave the joints unglued so the frame comes apart for storage.
- Foam board. Hinge foam board panels together with tape. The box folds flat for storage. Use the same diffusion on any openings.
Lighting the box
- Two lamps. Place one lamp on each side, at about 45 degrees to the box and aimed at the center. A third lamp on top is optional.
- Matched bulbs. Use the same brand and type of bulb, at about 5000 to 5600K with CRI 90 or higher. Mismatched bulbs give uneven color that is hard to correct later.
- Keep bulbs back from the diffusion. Even LEDs can warm up thin material, so leave a few inches of space.
Camera settings
- Use a tripod. A remote release or a 2-second timer prevents shake.
- Start at base ISO. Base ISO, often 100, gives the cleanest image.
- Use f/8 to f/11. This range keeps a small product sharp from front to back.
- Set a custom white balance. Place a gray card inside the box under the lights, and set the white balance from it.
- Expose a little brighter than the meter. A meter tends to push white toward gray. Expose roughly 0.7 to 1.3 stops above the meter reading to keep white looking white. Check the histogram and adjust.
Common mistakes
- Using more diffusion layers than you need. Each layer costs about a stop of light.
- Expecting one box to suit every product. Large or highly reflective items need a bigger box, more lights, or black cards to control reflections.
- Mixing bulbs. Mismatched color is hard to fix afterward.
- Trusting the meter for white backgrounds. Check the result and adjust the exposure.
Safety
- Use LED bulbs only. Incandescent and halogen bulbs can scorch tissue paper and cardboard.
- Keep bulbs a few inches from the diffusion, even when they are LEDs.
- Use a sharp craft knife with a straightedge, cutting away from your hand.